- 地址：
- 安國市南陽工業區
- 郵箱：
- 415130881@qq.com
- 電話：
- 18631165157
- 傳真：
- 0312-3427286
- 手機：
- 18631165157
立式渣漿泵與臥式渣漿泵的結構
如其結構較簡單，進、出口同在一水平線上，可直接安裝在管道中，電機在上面，占地面積很小。壓水室一般為螺旋形蝸殼，泵本身可以沒有軸承，直接用電機軸承，對功率大的，泵本身要有自己的軸承，軸封般為機械密封，也可以用填料。
六、立式浸沒式泵
如圖2-17所示。其泵將葉輪浸沒于液體之中，啟動時無需灌水或抽真空，使用非常方便，占地面積小， 泵的基礎也很小。圖2-17 為單管式的浸沒泵，即泵軸和揚水同在一管中。在作為污水泵時，揚水管可做成雙管式的，即泵軸在一管中，被輸送的波體在另一管中流動，其葉輪可設計為無堵塞式的葉輪，更不易堵塞。
七、深井泵
如圖2-18所示，主要用于深井中把水提到地面上來。這種泵由于要下到深井中去，受到井徑的限制，所以是細長的。深井泵一般用立式電機，裝在地面的泵座上，經很長的傳動軸帶動井下的葉輪轉動，通過很長的揚水管將井水提上來。它實際也是立式浸沒式的一種，不過它的外徑要求更小，泵更長。渣漿泵廠家
Structure of vertical slurry pump and horizontal slurry pump
Its structure is simple, the inlet and outlet are on the same horizontal line, and it can be directly installed in the pipeline, the motor is on it, and the floor area is very small. The water pressure chamber is generally a spiral volute, and the pump itself can have no bearing, and the motor bearing is directly used. For the high-power pump, the pump itself should have its own bearing, and the shaft seal is generally a mechanical seal or a packing.
Vi. vertical immersion pump
As shown in Figure 2-17. The pump submerges the impeller in the liquid, no need to fill water or vacuumize when starting, so it is very convenient to use, with small floor area and small foundation. Figure 2-17 shows a single tube submerged pump, i.e. the pump shaft and water lift are in the same tube. As a sewage pump, the water lift pipe can be made into a double pipe type, that is, the pump shaft is in one pipe, and the transported wave body flows in another pipe. The impeller can be designed as a non blocking impeller, which is more difficult to block.
VII. Deep well pump
As shown in Figure 2-18, it is mainly used to lift water to the surface in deep wells. This kind of pump is long and thin because it is going to go down to deep well and limited by well diameter. The deep well pump generally uses the vertical motor, which is installed on the pump base on the ground, drives the downhole impeller to rotate through a long drive shaft, and lifts the well water through a long lifting pipe. It is actually a vertical immersion type, but its outer diameter is smaller and the pump is longer. Slurry pump manufacturer
