- 地址：
- 安國市南陽工業區
- 郵箱：
- 415130881@qq.com
- 電話：
- 18631165157
- 傳真：
- 0312-3427286
- 手機：
- 18631165157
渣漿泵的幾種常用結構分段式多級泵
如圖2-15所示，這種結構泵使用也極廣泛。它實際上相當于將幾個葉輪裝在一根軸上串聯工作，所以泵的揚程可以比較高，每個葉輪均有相應的導葉。第一級葉輪一般是單吸的，但為了改善泵的汽蝕性能，可將第一級葉輪 制成雙吸。泵的軸承在泵軸的兩端支承，功率小的泵用滾動軸承，功率大的泵用滑動軸承，稀油潤滑，甚至需要用強制潤滑方式。軸向力的平衡常采用平衡盤結構或平衡鼓結構。采用平衡盤結構時，整個轉子可以左右竄動，靠平衡盤自動的將轉子維持在平衡位置上。少數還有采用平衡孔結構。渣漿泵廠家
Several commonly used structure of slurry pump
As shown in Figure 2-15, this kind of structural pump is also widely used. In fact, it is equivalent to several impellers installed on a shaft in series, so the pump head can be relatively high, and each impeller has corresponding guide vanes. The first stage impeller is generally single suction, but in order to improve the cavitation performance of the pump, the first stage impeller can be made into double suction. The bearing of the pump is supported at both ends of the pump shaft, the rolling bearing for the pump with small power, the sliding bearing for the pump with large power, thin oil lubrication, and even forced lubrication. The balance of axial force usually adopts the structure of balance disk or balance drum. When the balance plate structure is adopted, the whole rotor can move left and right, and the balance plate can automatically maintain the rotor in the balance position. A few of them use balance hole structure. Slurry pump manufacturer
